Mass Balance of Hydrocarbons Fuel from Waste Cooking Oil and Plastic by Co-Pyrolysis

Authors

  • Fajar H. Limbong UPN "Veteran" Jawa Timur
  • Delphy Y. A. Praja UPN "Veteran" Jawa Timur
  • Ardika Nurmawati UPN "Veteran" Jawa Timur
  • Ika N. Puspitawati UPN "Veteran" Jawa Timur
  • Erwan A. Saputro UPN "Veteran" Jawa Timur

DOI:

https://doi.org/10.22487/j24775185.2025.v14.i3.pp132-137

Keywords:

Bio oil, copyrolysis, HDPE, Not biofuel , WCO

Abstract

Indonesia has committed to climate change mitigation through a sustainable energy transition. Currently, the share of renewable energy in Indonesia’s energy mix only reaches 12 %. One type of renewable energy that the Indonesian government is focusing on is biofuel to reduce consumption and dependence on fossil fuels. Bio-oil produced through pyrolysis has the potential to be used as a biofuel. The chosen pyrolysis process is Co-Pyrolysis, which involves two or more feedstocks. In this study, the process was carried out using waste cooking oil (WCO) and HDPE waste as feedstocks. The process was conducted at 450°C for 30 minutes, with varying masses of both feedstocks. The data obtained were analyzed using mass balance and yield analysis to determine the optimal conditions for producing bio-oil as a hydrocarbon fuel. The optimal condition was found at a mass ratio of HDPE: WCO = 1:4, with a bio-oil yield of 78%. Under these optimal conditions, the conversion of HDPE plastic into heptadecane was 29.39%, and the conversion of oleic acid in waste cooking oil into heptadecane was 38.8%. This also serves as an initial step toward developing a pilot plant-scale process using HDPE plastic waste and waste cooking oil.

Author Biographies

Fajar H. Limbong, UPN "Veteran" Jawa Timur

Chemical Engineering Department

Delphy Y. A. Praja, UPN "Veteran" Jawa Timur

Chemical Engineering Department

Ardika Nurmawati, UPN "Veteran" Jawa Timur

Chemical Engineering Department

Ika N. Puspitawati, UPN "Veteran" Jawa Timur

Chemical Engineering Department

Erwan A. Saputro, UPN "Veteran" Jawa Timur

Chemical Engineering Department

References

Adiwardhana, A. (2023). Bahan bakar nabati sebagai energi alternatif dalam transisi energi. Buletin Pertamina Energy Institute, 9(3), 114–126.

Ahmed, G., & Kishore, N. (2023). Characterization of biofuel obtained by pyrolysis of A. Indica. In Sustainable Energy Generation and Storage. Singapore: Springer Nature Singapore.

Ardianti, D. A., Najib, A. A., Hakim, N. F., Setiorini, U., & Suryaningsih, S. (2019). Rancang bangun alat pengkonversi sampah plastik menggunakan metode pirolisis menjadi bahan bakar minyak dalam upaya penanganan masalah lingkungan. Jurnal Ilmu dan Inovasi Fisika, 3(2), 91–96.

Banchapattanasakda, W., Asavatesanupap, C., & Santikunaporn, M. (2023). Conversion of waste cooking oil into bio-fuel via pyrolysis using activated carbon as a catalyst. Molecules, 28(8), 1–18.

Chen, H., Yao, S., Lin, W., Zhang, Z., Hu, X., Liu, X., Yan, B., Chen, K., Qin, Y., Zhu, Y., Lu, X., Ouyang, P., Fu, J., & Chen, J. G. (2020). Highly efficient conversion of oleic acid to heptadecane without external hydrogen source over atomic layer deposited bimetallic NiPt catalysts. Chemical Engineering Journal, 390(June), 1–10.

Diaz-Silvarrey, L. S., Zhang, K., & Phan, A. N. (2018). Monomer recovery through advanced pyrolysis of waste high density polyethylene (HDPE). Green Chemistry, 20(March), 1813-1823.

Doran, P. M. (1995). Bioprocess engineering principles. Australia: Elsevier Science & Technology Books.

Dutta, N., Mondal, P., & Gupta, A. (2022). Optimization of process parameters using response surface methodology for maximum liquid yield during thermal pyrolysis of blend of virgin and waste high-density polyethylene. Journal of Material Cycles and Waste Management, 24(April), 1182–1193.

Habtewold, A. T., Ambie, D. A., & Eremed, W. B. (2020). Solar assisted pyrolysis system for high-density polyethylene plastic waste to fuel conversion. AIMS Energy, 8(3), 455–473.

Helbawanti, O., Nuraini, C., Ulfa, A. N., & Mutolib, A. (2023). Potensi pasar minyak nabati jagung, kelapa, kacang tanah, biji bunga matahari, kedelai dan kelapa sawit sebagai bahan bakar alternatif (biofuel). Suluh Pembangunan: Journal of Extension and Development, 5(1), 75–84.

Himmelblau, D. M., & Riggs, J. B. (2022). Basic principles and calculations in chemical engineering (9th edition). London: Pearson Education Limited.

Kedir, W. M., & Asere, T. G. (2022). Biodiesel production from waste frying oil using catalysts derived from waste materials. Journal of the Turkish Chemical Society Section A: Chemistry, 9(3), 939–952.

Khan, M. I., Shin, J. H., & Kim, J. D. (2018). The promising future of microalgae: current status, challenges, and optimization of a sustainable and renewable industry for biofuels, feed, and other products. Journal Microbial Cell Factories, 17(March), 1–21.

Kraiem, T., Hassen, A. B., Belayouni, H., & Jeguirim, M. (2016). Production and characterization of bio-oil from the pyrolysis of waste frying oil. Environmental Science and Pollution Research, 24(September), 9951–9961.

Kulkarni, P., Ravekar, V., Rao, P. R., Waigokar, S., & Hingankar, S. (2022). Recycling of waste HDPE and PP plastic in preparation of plastic brick and its mechanical properties. Cleaner Materials, 5(July), 1–7.

Ministry of Energy and Mineral Resources Republic of Indonesia. (2023). Handbook of energy & economic statistics of Indonesia. Jakarta: Ministry of Energy and Mineral Resources Republic of Indonesia.

Nuraini., Osman, N. B., & Astuti, E. (2022). Bio-oil production using waste biomass via pyrolysis process: Mini review. Jurnal Bahan Alam Terbarukan, 11(1), 37-49.

Ong, P. J., Heng, Z. X. J., Xing, Z., Ko, H. Y. Y., Wang, P., Liu, H., Ji, R., Wang, X., Tan, B. H., Li, Z., Xu, J. W., Loh, X. J., Ye, E., & Zhu, Q. (2023). Wax from pyrolysis of waste plastics as a potential source of phase change material for thermal energy storage. Transactions of Tianjin University, 29(December), 225–234.

Rahman, M. H., Bhoi, P. R., Saha, A., Patil, V., & Adhikari, S. (2021). Thermo-catalytic co-pyrolysis of biomass and high-density polyethylene for improving the yield and quality of pyrolysis liquid. Energy, 225(March), 1–13.

Rahmayani, C. A., & Aminah, A. (2021). Efektivitas pengendalian sampah plastik untuk mendukung kelestarian lingkungan hidup di kota semarang. Jurnal Pembangunan Hukum Indonesia, 3(1), 18–33.

Ramdhoani, R., & Javandira, C. (2023). Eksplorasi tanaman yang berpotensi sebagai sumber bahan bakar nabati di bukit jimbaran, Bali. Jurnal Ganec Swara, 17(3), 1089–1092.

Ridhuan, K., & Irawan, D. (2020). Energi terbarukan pirolisis. Lampung: CV. Laduny Alifatama.

Rodríguez-Luna, L., Bustos-Martínez, D., & Valenzuela, E. (2021). Two-step pyrolysis for waste HDPE valorization. Process Safety and Environmental Protection, 149(December), 526–536.

Salaudeen, S. A., Al-Salem, S. M., Sharma, S., & Dutta, A. (2021). Pyrolysis of high-density polyethylene in a fluidized bed reactor: pyro-wax and gas analysis. Industrial & Engineering Chemistry Research, 60(December), 1–10.

Sharma, P., Usman, M., Salama, E., Redina, M., Thakur, N., & Li, X. (2021). Evaluation of various waste cooking oils for biodiesel production: A comprehensive analysis of feedstock. Waste Management, 136(October), 219–229.

Sudalyandi, K., & Jeyakumar, R. (2022). Biofuel production using anaerobic digestion. Singapore: Springer Nature Singapore.

Wahyudi, J., Prayitno, H. T., & Astuti, A. D. (2018). Pemanfaatan limbah plastik sebagai bahan baku pembuatan bahan bakar alternatif. Jurnal Litbang: Media Informasi Penelitian, Pengembangan dan IPTEK, 14(1), 58–67.

Downloads

Published

2025-08-29

How to Cite

Limbong, F. H., Praja, D. Y. A., Nurmawati, A., Puspitawati, I. N., & Saputro, E. A. (2025). Mass Balance of Hydrocarbons Fuel from Waste Cooking Oil and Plastic by Co-Pyrolysis . Jurnal Akademika Kimia, 14(3), 132–137. https://doi.org/10.22487/j24775185.2025.v14.i3.pp132-137

Issue

Section

Articles